Turf Marking Paint may be used for utility marking, construction sites, surveying, landscaping, golf course and athletic field marking. Uses advised against: This aerosol product is designed to spray upside down or at an angle not greater than 30ยฐ from vertical. Do not apply if surface is wet, or if rain is imminent within 4 hours of application. Do not allow product to freeze.
Description: Aervoe Turf Marking Paint is a highlypigmented, durable water-based paint designed to mark and adhere to most surfaces. Packaged to operate upside down by hand or in an Aervoe #244 Spot Marker or #245 Marking Stick applicator with or without the cap on.
Benefits: This product is a true water-based formula, not “water-added” for cost reduction. It is covered by its own U.S. patent #5,158,609. Aervoe Turf Marking Paint will not damage or burn grass roots. It provides a lasting line that can be cut off after the grass has grown out. Adhesion to asphalt and concrete is equal to solventbased formulas once dried. Overspray can be cleaned up in the first 5 minutes with soap and water. After dry, paint is water-resistant. Uniquely formulated, this paint is lead-free, non-clogging, and safer for the environment than solvent-based formulas. This product is classified under the NFPA 30B, Level 1 for warehouse storage.
Application: Turf Marking Paint may be used for utility marking, construction sites, surveying, landscaping, golf course and athletic field marking. For temporary marking, use Aervoe Spray Chalk or Fugitive Marker. For aisle striping in warehouses, parking lots or traffic lines, use Aervoe Striping Paint.
Directions: Aervoe Turf Marking Paint is intended for use with Aervoe’s #244 Spot Marker and #245 Marking Stick; test other applicators for compatibility. For best results, use at temperatures between 60ยฐ and 80ยฐF (16ยฐ and 27ยฐC). For Aerosol application, shake can for 1 to 2 minutes after rattle of agitator ball is heard. Remove safety tab, invert can and apply 3 to 5 inches from the surface for writing symbols and numbers. Spray 5 to 8 inches from surface for 3/4″ line or continuous direction tracks. Keep can in motion during use to prevent puddling due to the high delivery paint stream. If cap has been removed, replace it for storage and color identification. Before storing partially used cans, clear spray tip by holding can in upright position and pressing tip to one side, away from face, for 2-3 seconds.